LD1K & 1000L Motorcycle Lift Table Replacement Hydraulic Pump
[LD1K-HP [RP-1010-1KLDML-1]]

• NED M. Dec 3, 2019

  Dec 3, 2019

  I purchased this along with the LD1K/1000L Base to upgrade my harbor freight lift. After the necessary modifications this thing performs great.
• Chad Confer Jan 15, 2023

  Jan 15, 2023

  Fit perfect! A little adjustment on the manual pump lever was all I had to modify. You will need a 1in dia x 13in long pin to install. Cut in half for the pins. GTG! FROM REDLINE STAFF: We suspect this customer is talking about installing this pump on a different table, such as a Harbor Freight table, but we cannot be sure as he does not specify. Given that this pump is a direct bolt-in replacement on a Redline LD1K lift with no modification needed, we're certain this customer has not installed this pump into the Redline LD1K.
• Joseph Paolucci May 20, 2020

  May 20, 2020

  The modification was not that difficult. You have to move the cup that the pump ram sits in on the "V" plate back about an inch and a half or more. Move the tabs on the foot controls to match the pumps manual controls, and get a 25MM rotatory shaft to make two pins that 150MM each in length to mount in the table.
• Dave Tucker Jan 27, 2023

  Jan 27, 2023

  Thanks Redline for providing me with a direct replacement for my HF motorcycle lift! The only modification I had to make was to the manual pump linkage alignment, which was very simple using a spacer and bolt to offset the linkage. NO WELDING necessary! There was no need to buy the 1" round stock as I used the existing 1" pivot rod stock from the old pump. The conversion took maybe an hour.
• Vincent Dorsey Dec 6, 2023

  Dec 6, 2023

  This was used as a replacement to the original pump to a Harbor Frieght lift. I got lucky and found I have a direct switch. No issues in changing it out. Just should have bought the hoses along with it.
  
• Mike Jun 18, 2024

  Jun 18, 2024

  I bought the pump to replace the one on my harbor freight lift. It works great. I would recommend the pump to anyone who needs one.
• Jimmy Oct 20, 2024

  Oct 20, 2024

  Everything went good very little alteration On manual pump rod
• David Oct 29, 2024

  Oct 29, 2024

  If you have one of these motorcycle tables with a foot pump you can upgrade to this and it's a game changer it's awesome.
• John Jan 3, 2025

  Jan 3, 2025

  Recieved my jack. It was well packaged and in good condition. Installed it and at first it did not operate. I stopped and waited to call the tech line so as not to cause issues. I spoke to Justin who was very helpful an sent me a short video of how to bleed it. All ended up fine and works as it should.