The posts will work with a 10 foot ceiling height?

The TP9KFX has an overall height of approximately 112 inches which is less than 10 feet. The lift will fit if you have a 10 foot ceiling, but be sure to follow the instructions in the manual and be careful not to raise the vehicle too high and hit your ceiling. Thanks for reaching out Willie!

would the lift arms be close enough together to be able to put a UTV on it?

Short answer, it 'should.' Based on the diagram in the manual (available to view in the downloads tab above), the distance between carriages is approx. 100.8' and the arms are adjustable from 31.2'-45.4'. If the arms were pointed at 90-degrees to the carriage, that would leave a 10' gap between them with both arms fully extended. That gap increases as you change the arm angle. Please reference the drawing in the manual and compare to your UTV's lifting points so you can measure and make sure. Thanks for reaching out Patrick!

Kernel X Series 2 Post Lift | 2 post vehicle lift

The Kernel 9,000 lb. 2 Post X Series Style Floorplate Lift is ideal for auto enthusiasts or automotive service shops. It comes with a 220 Volt power unit that is easily adaptable to most commercial applications. It has a chain drive, dual point lock release, internal hose routing with integrated hose guards, and everything else you'd expect from a quality lift. Includes stackable 'drop-in' height adapters as well as 1 pair of saddle pad adapters. Order yours today!

KEY BENEFITS
• Chain drive
• Rubber door guards
• Powder coat finish
• Dual point lock release
• High quality construction
• 9,000 lb. lifting capacity
• Ideal for auto passenger cars
• Saddle pad adapters included (1 pair)
• Internal hose routing with integrated hose guards
• 4 stackable 1-3/8" and 4" 'drop-in' height adapters
• Reduced overall width with front-side power unit mounting
• Low profile 'drop-in' swivel pads with 1-1/2" adjustable height

RETURNS
• Our supplier does not accept returns on this item
• In event of warranty claim, replacement part(s) will be sent

• Min pad height: 4"
• Cable diameter: 3/8"
• Overall height: 111.9
• Max lifting height: 72"
• Power: 220V-20Amp, 1 PH
• Arm steel thickness: 6mm
• Lifting speed: 50 seconds
• Drive thru clearance: 101"
• Column size: 7.25" x 10.87"
• Max load per arm: 2,250 lbs.
• Width between columns: 110.4"
• Rear arm reach min/max: 31" - 45"
• Front arm reach min/max: 31" - 45"
• Lift type: symmetric / floor plate
• Overall width w/ power unit: 134.6"
• Column/carriage steel thickness: 5mm

• Browse the full manufacturer catalog HERE
• Download the spec pdf HERE
• Download the manual pdf HERE

• Download the How to Install a Two Post Auto Lift Manual HERE

• Shipping weight: 1,370 lbs.
• Residential deliveries not possible
• Can be picked up at local terminal
• Must ship to a business with forklift
• Free shipping applies to all 48 states except SD, ND and MT
• Free shipping applies to $700 maximum. If shipping exceeds this amount a surcharge may be needed
• Pickup at satellite warehouses:
- Temecula, CA 92590
- Boise, ID 83709
- West Valley, UT 84119
- Marshalltown, IA 50158
- Elwood, IN 46036
- Bow, NH 03304
- Wilmington, DE 19802
- Reidsville, NC 27320
- Norcross, GA 30071
- Orlando, FL 32809
- Alvarado, TX 76009
- Lowell, MA 01852
- Southfield, MI 48033 (no customer pick-ups allowed)