Do you sell a longer entry ramp to make it easier

We have this RAMP made by Titan. It’s not going to be a direct bolt-up for the 1500HD, but I’d imagine a little ingenuity would probably do the job. Thanks for shopping with us!

If I change my table over to electric instead of air will it lift more? I can barely lift a 1000lb mower at the moment and I'm running 135lb air pressure.

While it’s not necessary to convert your lift to electric in order to get it to lift 1,500 lbs, you can do so with THIS KIT. Just be sure to select that you want the 1500HD-E cylinder to go with it. The real problem here is that your pump’s relief pressure is set too low and needs to be raised. You can do so by watching THIS VIDEO. Once you adjust your pump’s pressure, you’ll be able to lift 1,500 lbs with it. Just don’t adjust the pressure so high that it will lift more than 1,500 lbs. You’ll start seeing permanent structural deformation of the frame at around 1,650 lbs. Thanks for your business!

I have a 12 yr old Redline 1500HD Motorcycle ATV Lift Table and I need the hydraulic hose that goes form the cylinder to the pump. where I get parts?

I believe you are looking for THIS? Thanks for shopping with us!

Will this lift my 2022 Harley Trike?

Probably. We have to say “probably” because we do not know the dimensions of your trike. You need to measure the width and the wheelbase to see if it will fit atop the 1500HD. Be sure to measure the “wheelbase” and not the “overall length.” Lots of folks don’t realize that you need to measure the axle to axle distance to see if the table is long enough, because the axle to axle distance tells you where the bike will actually touch the top of the table. The length from tip to tip is of no value in this consideration. Assuming the 1500HD is not long or wide enough, consider the TR1500 instead. Thanks for shopping with us!

If I upgrade thr 1500 lb lift table to electric will the table still come equipped with the hydraulics or is it all setup?

The electric upgrade replaces the air/hydraulic pump with an electric/hydraulic pump. The lift itself will have the proper cylinder for that pump already installed. When it arrives, you will need to connect the hydraulic hose, add the AW32 hydraulic fluid to the reservoir and plug it in. Simple as that. Thanks for reaching out T!

Redline 1500HD Motorcycle ATV Lift Table with Side Extensions

Move your mouse over image or click to enlarge

Redline LD1K 1000 lb. Light Duty Motorcycle Lift Table

$999.50

Handy PITBUL Portable Electric 3000 Lb. UTV Lift $4,169.95

Redline Electric 2200HD Lift Table with UTV/ATV Side Extensions

$4,799.50

K&L Supply Electric 2000 lb MC655R Motorcycle Lift Table

$3,999.50

Handy Gruntavore 1800 lb UTV Lift $3,799.50

iDEAL 2500 lb UTV ATV Lift Table $3,649.99

Redline 1500HD Motorcycle ATV Lift Table with Side Extensions

Model: 1500HD

(11 reviews)

Please Choose:

Optional Accessories

Include Redline Frame Jack ( +$189.95 )

Include RE-ATVJK ATV Frame Jack ( +$179.95 )

Include RMC1 Redline Wheel Chock ( +$149.95 )

Include Redline Roller Drop Out Panel ( +$149.50 )

Upgrade Air Pump to Commercial Grade ( +$374.50 )

Include Electric Motor Driven Upgrade ( +$749.50 ) - out of stock

Include Redline Frame Jack

Include RE-ATVJK ATV Frame Jack

Include RMC1 Redline Wheel Chock

Include Redline Roller Drop Out Panel

Upgrade Air Pump to Commercial Grade

Include Electric Motor Driven Upgrade

Capacity by LBS

1500

Brand

Redline Engineering

Type

Air over Hydraulic

Color

Shipping upgrades offered in cart page

$2,249.50

In Stock in

Pensacola

Usually Ships Within

24-48 Hrs

The Redline 1500HD is one of our most heavy duty air over hydraulic lifts. Everything is bigger with the 1500HD. It lifts to 43" high, is 101" long, and is about 4" wider than most standard lifts. The 1500HD's features include a 3 piece removable rear ramp section, free front extension panel, built-in casters, standard wheel vise, rear drop out panel, rear support poles, side extension panels, and a built-in safety lock system. Call us or enter your order online today!

Pump may arrive in black or grey color

KEY BENEFITS
• Covered by Redline's 1-Year parts warranty
• Casters raised/lowered via 10mm allen wrench
• Built in casters for easy moving (non load bearing)
• Vise mounts to table with/without front ext. panel
• Includes:
-Drop out panel
-Front extension panel
-Side extensions
-3 pc ramps
-Support poles
-Vise

UPGRADE TO ELECTRIC
• Pump is 110V
• Electric is smoother, quieter, and faster
• Air/hydraulic pump not needed or included
• Electric pump upgrade also includes larger hydraulic cylinder

OPERATE SAFELY
• Using motorcycle ratchet straps are mandatory for your safety
• Wheel vise alone not sufficient to secure motorcycle to lift table

• 43'' lifting height

• 8'' lowered height

• Tubing size: 3-1/8" x 1-5/8"

• 1,500 pound lifting capacity

• 80.5'' table length standard

• Side extensions are 88.5" long

• Base measures 87.5" x 29.5"

• Chopper extension is 20 ¾" long

• Overall length including ramps 125"

• Drop out panel is 17" wide x 20" long

• Minimum 100 psi required to operate

• Air motor requires 7 CFM of air supply

• Constructed of 11 gauge steel .125" thick

• Upgraded electric pump outputs 28 MPA

• 101'' table length with free included front extension

• 750 lb combined capacity for rear upright support poles

• 6 Locking Positions (23", 27 ½", 31 ¼", 34 ¾", 37 ½", and 40")

• 29.5'' table width without side panels / 51'' with side panels installed

• Download the manual pdf HERE
• Download the pump diagram HERE
• Download the pump vent letter HERE

• Download the motorcycle lift table comparison chart HERE

• Residential deliveries cost extra

• 1500HD: 767 lbs. @ 91" x 37" x 16 (Class 65)

• 1500HD Pump: 31 lbs. @ 25" x 11" x 9"

• 1500HD Commercial Pump: 9 lbs. @ 14" x 8" x 8"

• 1500HD Electric Pump: 76 lbs. @ 40" x 16" x 20" (Class 125)

• Local dock pickup saves residential fees

• Pensacola, FL pickups – read our policies HERE

• FREE shipping to commercial location w/ forklift*

• Units available in Pensacola, FL with $200 discount

• Free shipping applies to $250 maximum. If shipping exceeds this amount a surcharge may be needed

iDEAL 2200 lb Motorcycle Trike/ATV/UTV Lift Table

$3,399.99

Redline MC1K 1000 lb Motorcycle ATV Lift Table

$1,199.50

iDEAL 2500 lb UTV ATV Lift Table $3,649.99

K&L Supply Electric 2000 lb MC655R Motorcycle Lift Table

$3,999.50

Handy Gruntavore 1800 lb UTV Lift $3,799.50

Redline LD1K 1000 lb. Light Duty Motorcycle Lift Table

$999.50

Reviews

4.6 / 5 (11 reviews)

Based on 11 Reviews Write review

DR Nov 25, 2024

Great Lift
Nov 25, 2024

it does everything it is suppose to do !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
RG Jun 11, 2024

Very nice lift
Jun 11, 2024

Lift came very fast with no issues. Directions weren't the best but figured it out. It is very well made. Did not get the electric motor and it works just fine and moves quick. I have a Ultra Limited and it fits great. Plenty of room. No regrets and would buy again.
Steven Plummer Apr 21, 2024

1500HD Lift Table
Apr 21, 2024

I ordered this lift with pickup at the freight facility. The facility never called to say it was in so I contacted redline customer service and the problem was handled immediately. After receiving the table assembly was pretty straightforward. The lift works great and lifts my Harley Limited with no problems. This lift definitely saves my back and makes working on my bike much easier. Thanks Resline for a great product

Ask & Answer

Gasman Jun 18, 2023

Q. Do you sell a longer entry ramp to make it easier
A. We have this RAMP made by Titan. It’s not going to be a direct bolt-up for the 1500HD, but I’d imagine a little ingenuity would probably do the job. Thanks for shopping with us!
Stan Jun 06, 2023

Q. If I change my table over to electric instead of air will it lift more? I can barely lift a 1000lb mower at the moment and I'm running 135lb air pressure.
A. While it’s not necessary to convert your lift to electric in order to get it to lift 1,500 lbs, you can do so with THIS KIT. Just be sure to select that you want the 1500HD-E cylinder to go with it. The real problem here is that your pump’s relief pressure is set too low and needs to be raised. You can do so by watching THIS VIDEO. Once you adjust your pump’s pressure, you’ll be able to lift 1,500 lbs with it. Just don’t adjust the pressure so high that it will lift more than 1,500 lbs. You’ll start seeing permanent structural deformation of the frame at around 1,650 lbs. Thanks for your business!
Brad May 15, 2023

Q. I have a 12 yr old Redline 1500HD Motorcycle ATV Lift Table and I need the hydraulic hose that goes form the cylinder to the pump. where I get parts?
A. I believe you are looking for THIS? Thanks for shopping with us!
Skull Apr 18, 2023

Q. Will this lift my 2022 Harley Trike?
A. Probably. We have to say “probably” because we do not know the dimensions of your trike. You need to measure the width and the wheelbase to see if it will fit atop the 1500HD. Be sure to measure the “wheelbase” and not the “overall length.” Lots of folks don’t realize that you need to measure the axle to axle distance to see if the table is long enough, because the axle to axle distance tells you where the bike will actually touch the top of the table. The length from tip to tip is of no value in this consideration. Assuming the 1500HD is not long or wide enough, consider the TR1500 instead. Thanks for shopping with us!
T Mar 17, 2023

Q. If I upgrade thr 1500 lb lift table to electric will the table still come equipped with the hydraulics or is it all setup?
A. The electric upgrade replaces the air/hydraulic pump with an electric/hydraulic pump. The lift itself will have the proper cylinder for that pump already installed. When it arrives, you will need to connect the hydraulic hose, add the AW32 hydraulic fluid to the reservoir and plug it in. Simple as that. Thanks for reaching out T!