A 30 ton shop press delivers a true 60,000 lb of straightening, bending, and pressing force—perfect for busy garages, fabrication shops, and serious DIYers who handle truck-grade or industrial components. Redline Stands offers only welded H-frame presses with hardened steel arbor plates, multi-position beds, and smooth ram control (manual hand pump or air/hydraulic). Whether you’re pressing wheel bearings out of a ¾-ton pickup or forming mild-steel brackets for a prototype, a 30 ton press gives you the capacity headroom to work safely without stepping up to a bulkier 50 ton machine.

TYPICAL JOBS FOR A 30 TON PRESS

• Automotive bearing and bushing service: remove and install wheel bearings, U-joints, and suspension bushings on light-duty and medium-duty trucks.
• Straightening bent components: realign steering knuckles, control arms, and structural tubing without excessive heat.
• Fabrication and metal forming: create brackets, gussets, and flat bar with brake-press or V-block attachments.
• Press-fit assembly: seat gears, sprockets, and pulleys onto shafts with precise, gauge-verified pressure.
• Chassis and suspension work: press out ball joints, kingpins, and leaf-spring bushings that defeat lesser-tonnage presses.
• Prototype and R&D tasks: quickly prove concepts or small-batch parts on a compact footprint that still offers industrial force.

30 TON SHOP PRESS FAQ

What PSI range is ideal for a 30 ton press?

Most 30 ton hydraulic cylinders reach rated capacity between 8,000 psi and 10,000 psi. Check your gauge and stop below the redline printed by the manufacturer. Running at lower pressures for lighter jobs extends seal life and reduces heat buildup.

How thick can a 30 ton press bend mild steel with a brake attachment?

With a standard 12-inch brake die, you can typically form ¼-inch (6 mm) mild steel at a 90-degree angle. Always verify the die rating and keep bends within the press’s throat width.

Is air/hydraulic faster than manual pumping on a 30 ton unit?

Yes. An air-assisted pump shortens the approach stroke and reduces operator fatigue, trimming cycle times by roughly 40 percent. You’ll still have manual control for the final tonnage to avoid over-pressing delicate parts.

How often should the hydraulic oil be changed?

For daily shop use, replace oil every 12 months or 500 hours, whichever comes first. Inspect sooner if you notice jerky ram movement or frothy fluid in the sight glass.

Can a 30 ton press handle heavy-duty truck wheel bearings?

Absolutely. A properly supported hub assembly and V-block setup let you service most Class 3-5 truck bearings without pushing the press to its limit. For Class 6 and above, step up to a 50 ton model for extra safety margin.

What footprint and clearance do I need?

Allow a floor space of roughly 40 in × 30 in (1 m × 0.75 m) plus about 24 in of clearance in front and above the ram for bulky workpieces and hoist access.

Disclaimer

The tips and examples above are provided for general information only. Every press, workpiece, and shop setup is different. It is the user’s sole responsibility to:

1. Read and understand the complete owner’s manual for the specific 30 ton press and any attachments being used.
2. Confirm all pressure limits, safety procedures, and maintenance requirements found in that manual.
3. Seek guidance from qualified technicians or engineers whenever there is uncertainty about a job, fixture, or material specification.

Redline Stands is not liable for damage, injury, or loss resulting from misuse, improper setup, or failure to follow manufacturer instructions and professional advice. Always verify that your equipment, tooling, and methods are appropriate for the task before applying hydraulic pressure.